Sony MHC-RV6/RV5 Stereo System User Manual


 
Tuner
21
GB
Setting presets through
manual tuning
1 Press TUNER/BAND repeatedly to
select FM or AM.
2 Press or + (or TUNING or + on the
remote) repeatedly to tune in the
desired station.
3 Press TUNER MEMORY.
A preset number appears in the display.
The stations are stored from preset number
1.
4 Press . or > (or PRESET or +
on the remote) repeatedly to select the
desired preset number.
5 Press ENTER.
6 Repeat steps 1 to 5 to store other
stations.
Other Operations
To Do this
Follow the procedure described in
Setting presets through manual
tuning.
Start over from step 1. After step
3, press . or > (or PRESET
or + on the remote) repeatedly to
select the preset number you want
to store the other station.
To change the AM tuning interval
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding down
ENTER, turn the system back on. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the
same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
The preset stations are retained for half a day even
if you disconnect the power cord or if a power
failure occurs.
To improve broadcast reception, reorient or move
the supplied antenna near a window or outdoors.
Tune in a station
with a weak
signal
Set another
station to an
existing preset
number