Filter
Top Products
Additional Information
49
Before placing a cassette in the
tape deck
Take up any slack in the tape. Otherwise the tape may
get entangled in the parts of the tape deck and become
damaged.
When using a tape longer than
90 minutes
The tape is very elastic. Do not change the tape
operations such as play, stop, and fast-winding etc.
frequently. The tape may get entangled in the tape
deck.
Cleaning the tape heads
Clean the tape heads after every 10 hours of use.
When the tape heads become dirty;
— the sound is distorted
— there is a decrease in sound level
— the sound drops out
— the tape does not erase completely
— the tape does not record
Make sure to clean the tape heads before you start an
important recording or after playing an old tape. Use
separately sold dry-type or wet-type cleaning cassette.
For details, refer to the instructions of the cleaning
cassette.
Demagnetizing the tape heads
Demagnetize the tape heads and the metal parts that
have contact with the tape every 20 to 30 hours of use
with a separately sold demagnetizing cassette. For
details, refer to the instructions of the demagnetizing
cassette.
Troubleshooting
If you have any problem using this system, use the
following check list.
First, check that the power cord is connected
firmly and the speakers are connected correctly
and firmly.
Should any problem persist, consult your nearest
Sony dealer.
General
The display starts flashing as soon as you
connect the power cord even though you
haven’t turned on the power
(demonstration mode).
• Press DISPLAY when the power is turned off.
The demonstration mode appears
automatically the first time you connect the
power cord. If there is a power outage lasting
longer than half a day, redo the following:
— Clock setting (see “Step 3: Setting the
time” on page 9)
— Preset stations (see “Step 4: Presetting
radio stations” on page 10)
— Timer settings (see “Waking up to music”
on page 41 and “Timer-recording radio
programs” on page 43).
There is no sound.
• Turn VOLUME clockwise.
• The headphones are connected.
• Insert only the stripped portion of the speaker
cord into the SPEAKER jack. Inserting the
vinyl portion of the speaker cord will obstruct
the speaker connections.
continued