Filter
Top Products
40
VOLUME
REC
VOLUME
REC
3 Turn jog dial to select REC, then
press ENTER/NEXT.
“ON” appears and the hour digits flash
in the display.
4 Set the time to start recording.
Turn jog dial to set the hour, then press
ENTER/NEXT.
The minute indication starts flashing.
Turn jog dial to set the minute, then
press ENTER/NEXT.
The hour indication flashes again.
5 Set the time to stop recording
following the above procedure.
The start time appears, followed by the
stop time, the recording source and the
radio station, then the original display
appears.
6 Insert a recordable tape.
7 Turn off the power.
When the recording starts, the volume
level is set to the minimum.
To check the setting
Press TIMER SELECT and turn the jog dial to
select “REC”, then press ENTER/NEXT. To
change the setting, start over from step 1.
To cancel the timer operation
Press TIMER SELECT and turn the jog dial to
select “OFF”, then press ENTER/NEXT.
Notes
•When setting the timer-recording, set the equalizer
display to anything other than Spectrum analyzer
pattern 3 (see “To change the equalizer display”
on page 31).
•If the power is on at the preset time, the recording
will not be made.
Timer-recording radio programs
(continued)