Filter
Top Products
58
GB
Manual tuning preset
You can manually tune in and store the
frequency of your favourite stations.
1 Press FUNCTION +/– repeatedly to
select “TUNER FM” or “TUNER AM”
(or press TUNER/BAND on the unit
repeatedly to select “FM” or “AM”).
2 Press TUNING +/– repeatedly to tune in
the station you want.
3 Press MENU.
“MEMORY” flashes in the display.
4 Press ENTER.
A preset number flashes in the display.
The stations are stored from preset
number 1.
5 Press PRESET +/– repeatedly to select
the preset number you want.
6 Press ENTER.
“COMPLETE” appears in the display. The
station is stored.
7 Repeat steps 1 to 6 to store other
stations.
Other operations
To change the AM tuning interval
(except for Saudi Arabian and
Russian models)
The factory setting for AM tuning interval is
9 kHz (or 10 kHz for some areas).
Use the buttons on the unit for the operation.
1 Press TUNER/BAND repeatedly to select
“AM”.
2 Press ?/1 to turn off the system.
3 Hold down ILLUMINATION and then press
?/1 to turn on the system.
“AM 9K STEP” or “AM 10K STEP” appears
in the display.
When you change the interval, all the AM preset
stations are erased. To reset the interval, repeat
the same procedure.
Note
You cannot change the AM tuning interval in Power
Saving Mode (page 76).
Tips
• The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
• If you press TUNER/BAND on the unit while the
system is turned off, the system turns on
automatically and “TUNER” is selected as the
function except during Power Saving Mode.
To Do this
Tune in a station
with a weak signal
Follow the procedure described
in “Manual tuning preset”
(page 58).
Stop scanning
during automatic
tuning
Press x.
Cancel presetting Press MENU.
GROOVE
A B
Preset number