Filter
Top Products
Getting Started
17
GB
Notes
• Keep the speaker cords away from the antennas to
prevent noise.
• Be sure to match the color of the speaker terminals on
the unit and the connectors.
• Be sure to connect the speakers securely and
correctly. When connecting speaker cords, insert the
connector straight into the terminals.
• You cannot set the color system in the Power Saving
Mode (see “Turning off the display” on page 76).
• When you play back a VIDEO CD recorded in a
different color system from the one you set to the
system, the picture image may be distorted.
To connect optional components
See “Hooking up optional components” on
page 81.
Using the remote
Inserting two R6 (size AA)
batteries into the remote
Be sure to match the e and E ends on the
batteries to the markings inside the
compartment. When using the remote, point it to
the remote sensor on the unit.
Operating a Sony TV with the
remote
You can use the following buttons to operate a
Sony TV. These buttons have been marked in
orange. To use these buttons, hold down TV
before pressing the button you want.
* For double digit number, hold down TV and press
-/--, then press the number. (For example, hold down
TV, press -/--, then 2 and 5 for entering 25.)
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Tip
With normal use, the batteries should last for about six
months. When the remote no longer operates the
system, replace both batteries with new ones.
Attaching the speaker pads
Attach the supplied speaker pads to the bottom
corner of the speakers to stabilize the speakers
and to prevent them from slipping.
Example of MHC-GN999D front speaker
To Hold down TV and
press
Turn the TV on or off TV ?/1
Switch the TV’s input
source between the TV
and other input sources
TV/VIDEO
Select the TV channels TV CH +/– or numeric
buttons*
Adjust the volume of the
TV speaker(s)
TV VOL +/–