Sony MHC-EX660 Stereo System User Manual


 
64
EN
4 Set the time to start playback.
Turn MULTI CONTROLLER to set the
hour, then press ENTER/NEXT.
The minute indication starts flashing.
Turn MULTI CONTROLLER to set the
minute, then press ENTER/NEXT.
“OFF” appears and the hour indication
flashes again.
5 Set the time to stop playback
following the procedure in step 4.
6 Turn MULTI CONTROLLER until
the sound source you want appears.
The indications change as follows:
CD PLAY n TUNER n TAPE PLAY
n MD PLAY
7 Press ENTER/NEXT.
The start time, followed by the stop time
and the sound source appears, then the
original display appears.
8 Adjust the volume and turn off the
power.
To change the setting
Start over from step 1.
To check the setting
Press DAILY to turn on the indicator. If the
indicator is already lit, press the button once
to turn off the indicator, then press it again.
The start time, followed by the stop time and
the sound source appears, then the original
display appears.
To cancel the timer operation
Press DAILY to turn off the indicator.
Tip (for DHC-MD77/EX77MD/EX770MD)
When you connect the optional TC-TX77/TX770
deck to the system with the audio bus cable (see
page 12), you can activate the wake-up timer with
the tape deck.
Notes
•Do not operate the system from the time the
power turns on until the playback starts (about 40
seconds).
•If “OFF TIME NG !” appears, the timer-on and -off
settings are the same. Change the time to turn off.
Waking up to music (continued)