Filter
Top Products
30
EN
Selected track
Playing time
Tips
•To program the entire CD as one step of the
program, skip step 4.
•When you want to record the program, see
“Recording the favorite CD tracks on an MD” (see
page 38) or “Recording the favorite CD tracks on a
tape” (see page 54).
•The program you made remains after the Program
Play has finished. To play the same program
again, press · ∏. However, when you make a
recording with the Hit Parade feature, the
program is erased.
• The total playing time is not displayed when you
select a track whose number is 21 or over, or the
total program time exceeds 100 minutes.
4 Turn SELECTOR until the desired
track number appears.
5 Press ENTER.
The track is programmed. The last
programmed track appears, followed by
the total playing time. If you have made
a mistake, press CLEAR.
6 To program additional tracks,
repeat steps 3 to 5.
Skip step 3 if you select a track from the
same disc.
7 Press · ∏ (or · on the remote).
All the tracks play in the order you
selected.
To check the total number of the
programmed tracks
Press TIME in stop mode.
“Step” appears, followed by the total number
of the programmed tracks.
To
Cancel Program
Play
Clear a track
from the end
(in stop mode)
Add a track to
the program
(in stop mode)
Clear the entire
program
Programming the CD tracks
(continued)
Do this
Press CONTINUE.
Press CLEAR.
Do steps 3 to 5 in
“Programming the CD
tracks.”
Press p once in stop mode.