Sony MHC-EX660 Stereo System User Manual


 
37
EN
When the ANALOG IN indicator lights up
(analog recording), adjust the recording level
before starting recording. You cannot adjust
the recording level during digital recording.
1 Do steps 1 to 4 in “Recording on an
MD manually” on page 36.
2 Play the portion of the source you
want to record with the strongest
signal level.
3 Press REC LEVEL to extend the
control.
r REC
=
SELECTOR
+
0)
p
·
§
EJECT
0
10
=
SELECTOR
+
·∏
§
OPEN/CLOSE
ANALOG IN REC LEVEL
·
To stop recording
Press p on the MD deck.
If “OVER” appears in the level meter
A high-level signal was input during analog
recording. Reduce the recording level using REC
LEVEL (see this page), then re-record.
While “TOC” lights up or is flashing
Do not move the deck or pull out the power cord to
ensure the complete recording. The deck is
currently updating the Table Of Contents (TOC).
While “TRACK” is flashing
The deck is recording over an existing recording.
“TRACK” lights continuously while recording on a
blank portion of the MD.
Note
If you pause recording during CD recording, a track
number is recorded at that point. Also, note that the
tracks are recorded as a single track with a single
track number when:
• a single track of the same CD is recorded
repeatedly.
• two or more tracks with the same track number
from different CDs are recorded continuously.
Adjusting the
recording level
continued