Filter
Top Products
24
US
Additional Information
Additional Information
If you run into any problems using this headphone system, use the following checklist. Should
any problem persist, consult your nearest Sony dealer.
Symptom Cause and remedy
No sound
Check the connection between the processor and the AV component.
Check that the connected AV component’s optical digital output is set to
“ON” when selecting digital input.
Turn on the AV component connected to the processor, and start the
playback.
Turn on the processor and headphones.
Check that the INPUT switch on the processor is set to the component you
want to listen to.
If you connect the processor to an AV component using the headphones jack,
raise the volume level on the connected AV component as high as possible to
the extent that the sound is not distorted.
Raise the headphones volume.
The headphones’ power indicator goes off.
Charge the rechargeable battery if it is weak. If the power indicator is still
off after charging the battery, take the headphones to your nearest Sony
dealer.
You are trying to play a DTS audio track on a BD/DVD device that does not
support DTS.
Either use a BD/DVD device that supports DTS, or select a Dolby Digital
or PCM audio track.
You are playing back a BD/DVD disc recorded in DTS when DTS digital
output setting for the BD/DVD device (including GAME device) is “OFF.”
Refer to the operating instruction of your BD/DVD device, and change the
DTS digital output setting to “ON.”
You are playing back a BD/DVD disc recorded in DTS when the BD/DVD
device (including GAME device) and the processor are analog-connected.
Use the digital connection. (Analog sound may not be output from the
BD/DVD device.)
Set the sampling frequency of output signals for the device connected to
the processor to 48 kHz/44.1 kHz.
Troubleshooting