Filter
Top Products
34
Troubleshooting
If you experience any of the following difficulties while
using the amplifier, use this troubleshooting guide to help
you remedy the problem. Also, see “Checking the
connections” on page 20 to verify that the connections are
correct. Should any problem persist, consult your nearest
Sony dealer.
There’s no sound or only a very low-level sound
is heard.
, Check that the speakers and components are
connected securely.
, Make sure that you’ve selected the correct
component on the amplifier.
, Press MUTING on the remote if MUTING appears
on the display.
, The protective device on the amplifier has been
activated because of a short circuit. Turn off the
amplifier, eliminate the short-circuit problem and
turn on the power again.
The left and right sounds are unbalanced or
reversed.
, Check that the speakers and components are
connected correctly and securely.
, Adjust front balance parameter in the LEVEL
menu.
Severe hum or noise is heard.
, Check that the speakers and components are
connected securely.
, Check that the connecting cords are away from a
transformer or motor, and at least 3 meters (10 feet)
away from fluorescent light.
, Move your TV away from the audio components.
, The plugs and jacks are dirty. Wipe them with a
cloth slightly moistened with alcohol.
No sound is heard from the center speaker.
, Make sure the sound field function is on (press
SOUND FIELD MODE).
, Select a sound field containing the word “cinema”
or “virtual” (see pages 24 - 26).
, Adjust the speaker volume (see page 18).
, Select MICRO SP. from the SET UP menu (see
page 15).
Additional
Information