Filter
Top Products
Chapter 5 Editing
Chapter 5 Editing 5-1
5-1 Automatic Editing
Chapter 5 Editing
This section describes how to carry out automatic
editing with this unit and another VTR connected to
the REMOTE1-IN(9P) connector.
5-1-1 Overview
Editing mode
With this unit, you can use the following two edit
modes for automatic editing.
• Assemble editing
This is the editing mode in which successive portions
of the edited result are recorded on the end of the
already completed section.
The CTL signal, video signal, audio signal, and time
code are all newly recorded on the tape.
• Insert editing
In this mode, new material is recorded at an
intermediate point of an existing recording.
The CTL signal is not recorded. The video signal,
audio signal, and time code signal can all be
independently recorded.
You can carry out DMC editing in both editing modes.
In insert editing, split editing is also possible.
Using CTL to interpolate time code values
When you are using time code values as edit point
addresses, the time code must be recorded on the tape
in correct time sequence (i.e. the sections must be in
strictly ascending time order).
If the time code values are all in correct time sequence,
then if there are any discontinuities in the time code,
the unit allows them to be interpolated using the CTL
counter.
Recording time code
For automatic editing, regardless of the TCG (F1) and
PR/RGN (F2) settings, time code is recorded
continuously from the previous time code recorded on
the tape.
Using setup menu item 610, it is also possible to record time
code according to the settings in the function menu.
Sequence of editing operations
The following flowchart outlines the sequence of
operations in automatic editing with two VTRs.
Using an editing control unit
When controlling this unit with an editing control unit,
set an edit delay on the editing control unit so that cut
in and cut out instructions are output 5 frames before
the actual edit point.
Previewing the edit segments
(page 5-7)
Setting the recorder and player edit points
(page 5-3)
Amending edit points as necessary
(page 5-6)
Carrying out automatic editing
(page 5-8)
Checking the editing results as necessary
(page 5-9)
Selecting the editing mode
(page 5-3)