Filter
Top Products
16
Getting Started
To specify the balance and level of the speakers
1 Press TEST TONE on the remote.
You will hear the test tone from each speaker in
sequence.
2 Press AMP MENU repeatedly to display <<LEVEL >>
on the front panel display.
3 Sit at your listening position and select the item to
be adjusted using M/m.
• Items adjusted in << LEVEL >>
- Balance of the front and rear speakers
- Volume level of the center and rear speakers and
subwoofer
4 Adjust the volume level so that the volume of the
test tone from each speaker sounds the same using
</,.
The adjusted value will appear on the front panel
display.
5 Repeat Steps 3 and 4 to adjust other parameters
within <<LEVEL>>.
If you do not operate the remote for a few seconds, the
value turns off and is stored in the system.
6 Press TEST TONE again to turn off the test tone.
xBalance
You can vary the balance of each speaker as follows. The
default adjustments are in the parentheses.
•F
___I___ (center) (front speakers)
Adjust the balance between the front left and right
speakers (6 dB (L) to 6 dB (R), 1 dB steps).
•R
___I___ (center) (rear speakers)
Adjust the balance between the rear left and right
speakers (6 dB (L) to 6 dB (R), 1 dB steps).
xLevel
You can vary the level of each speaker as follows. The
default adjustments are in the parentheses.
• C. LEVEL (0 dB) (center speaker level)
Adjust the level of the center speaker (–6 dB to +6 dB,
1 dB steps).
• R. LEVEL (0 dB) (rear speakers level)
Adjust the level of the rear speakers (–6 dB to +6 dB,
1 dB steps).
• S. W. LEVEL (0 dB) (subwoofer level)
Adjust the level of the subwoofer (–6 dB to +6 dB,
1 dB steps).
z You can adjust the level of center/rear speakers and
subwoofer directly
Use the CENTER/REAR/WOOFER +/– buttons on the remote.
Speaker Setup
WS-FV10
floor stand
Notes
• When you select an item, the sound cuts off for a moment.
• Depending on the settings of other speakers, the subwoofer
may output excessive sound.
To adjust the volume of all the speakers at one
time
Use the VOLUME control.
Using the optional speaker stands
For greater flexibility in the positioning of the speakers,
use the optional WS-FV10 floor stand (available only in
certain countries).