Filter
Top Products
31
US
Getting Started – BASIC –
9 Connect the calibration mic to the
ECM-AC1 jack on the rear of the
subwoofer and set up the calibration
mic at the ear level using a tripod, etc.
(not supplied).
The front of each speaker should face the
calibration mic, and there should be no
obstruction between the speakers and the
calibration mic.
Note
• Place the calibration mic so that the “FRONT”
side of it is pointed toward the front speakers.
10Press X/x to select [YES], then press
.
[AUTO CALIBRATION] starts. Be quiet
during the measurement.
Note
•Loud test sound is output when [AUTO
CALIBRATION] starts. You cannot turn the
volume down. Give consideration to children
and neighbor.
• Avoid being in the measurement area and
making noise during the measurement (which
takes about 1 minute), as it may interfere with
measurement.
• If the sound of the surround speakers is not
output, adjust the wireless system. See
“Adjusting the IR transmitter and IR receiver of
the surround speaker (L)” (page 29).
• When you install the surround speaker (L) to the
right position, the system sets the “SL SR
REVERSE” setting (page 99) to “ON”
automatically.
11Unplug the calibration mic and press C/
c to select [YES].
Quick Setup is finished. All connections
and setup operations are complete.
Note
• Reflections from walls or the floor may affect
measurements.
• If measurement fails, follow the message then
retry [AUTO CALIBRATION].
To quit the Quick Setup
Press DISPLAY in any Step.
Ti
p
• If you cancel [AUTO CALIBRATION], perform the
speaker settings in “Settings for the Speakers”
(page 97).
• If you change the position of the speakers, reset the
speaker settings. See “Calibrating the Appropriate
Settings Automatically” (page 87).
• If you want to change any of the settings, see “Using
the Setup Display” (page 90).
• For details on [AUTO CALIBRATION] and the error
messages of [AUTO CALIBRATION], see
“Calibrating the Appropriate Settings Automatically”
(page 87).
VIDEO 1 VIDEO 2
VIDEO 2
TV VIDEO 1TV
AUDIO IN AUDIO IN AUDIO IN DIGITAL IN
OPTOCAL
L
R
DIGITAL IN
DIGITAL
IN
COAXIAL
COAXIAL
ECM-AC1
Calibration mic
Rear of the subwoofer
FRONT L :
FRONT R :
CENTER :
SUBWOOFER :
SURROUND L :
SURROUND R :
If OK, unplug calibration mic and select
YES.
YES
16ft 4.8m 0.0dB
16ft 4.8m 0.0dB
16ft 4.8m + 1.0dB
16ft 4.8m + 4.0dB
10ft 3.0m
-
2.0dB
10ft 3.0m
-
2.0dB
Measurement complete.
NO
cont
i
nue
d