Filter
Top Products
To check the timer setting
Press TIMER.
The selected source, the timer-on time, and the duration for the
timer-activated period will be displayed for 4 seconds.
To change any of the previous setting
Carry out from step 1.
However, if you do not change the timer-on time, in step 3 just
press ENTER twice and continue from step 4.
To cancel
the timer standby mode temporarily
Press TIMER so that 0 disappears.
To restore the timer standby mode, press TIMER again to display
a.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 and 6.
● Timer playback and timer recording will not begin unless the
power is turned off.
● Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
E
1 CD DIGITAL OUT
RaHa
(OPTICAL)
— VIDEO/AUX
IN
@@
6)(6)
Refer to the operating instructions of the connected equipment
for details.
● The connecting cords are not supplied. Obtain the necessary
connecting cords.
● Consult your local Aiwa dealer for optional equipment.
This unit can input analog sound signals through these jacks.
Use a cable with RCA phono plugs to connect audio equipment
(LD players, MD players, VCRs, TV, etc.).
Connect the red plug to VIDEO/AUX IN R jack, and the white
plug to
VIDEO/AUX IN Ljack.
PHONO IN JACKS
Connect a turntable. Use an AIWA turntable equipped with a
built-in equalizer amplifier.
This unit can output CD digital sound signals through this jack.
Use an optical cable to connect digital audio equipment (DAT
deck, MD recorder, etc.).
Remove the dust cap @ from the CD DIGITAL OUT (OPTICAL)
jack. Then, connect an optical cable plug to the CD DIGITAL
OUT (OPTICAL) jack.
\.
When the CD DIGITAL OUT (OPTICAL) jack is not being
used
Attach the supplied dust cap.
20 ENGLISH