Filter
Top Products
~
When the clock is set, the “:” between the hours and minutes
flashes. When the clock setting is canceled due to a power failure,
the entire clock display flashes.
1
2
3
Press Il.
When using the remote control, press CLOCK while pressing
Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute.
4 or - is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
Press ENTER or II.
The clock starts from 00 seconds
To
view the clock when another display is in the display
Press CLOCK while pressing SHIFT. The time is displayed for 4
seconds and then the original display reappears. However, the
clock cannot be displayed during recording.
To switch to the 24-hour standard
Press II and then press
■ within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
If the display flashes when the clock is displayed, it indicates
that the clock has stopped due to a power failure or the removal
of the power cord. The current time needs to be reset.
The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press SLEEP while pressing SHIFT on the remote
control.
2 Within 4 seconds, turn MULTI JOG or press ++
or -to specify the time until the power is turned
off.
The time changes between 5 and 240 minutes in 5-minute
steps.
Specified time
To check the time remaining until the power is turned off
Press SLEEP once while pressing SHIFT. The remaining time is
displayed for 4 seconds.
To
cancel the sleep timer
Press SLEEP twice while pressing SHIFT so that %.LEEPoFF
appears on the display.
If the power-economizing mode (page 7) is on, all the display
lights turn off when the power is turned off. To view the clock,
press II so that the time is displayed for 4 seconds.
18 ENGLISH