Filter
Top Products
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
R6(AA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
To
use SHIFT on the remote control
Buttons o have two different functions. One of these functions
is indicated on the button, and the other on the plate above the
button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the
button while pressing SHIFT.
To
use FUNCTION on the remote control
FUNCTION substitutes for the function buttons (TAPE/DECK
1/
2, TUNER/BAND, VIDEO/AUX, CD, MD) on the main unit.
Each time FUNCTION is pressed, the next function is selected
cyclically. When tapes are inserted in both decks, each deck is
selected with FUNCTION.
0/+
➤ PRESET on the remote control
The function is the same as that of +> on the main unit.
0
SHIFT
FUNCTION
W+ b
PRESET
m
● If the remote control is not going to be used for an extended
period of time, remove the batteries to prevent possible
electrolyte leakage.
● The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
ENTER
MULTI JOG
..— —
..
‘1
To turn the power on
Press one of the function buttons (TAPE/DECKl/2, TUNERI
BAND, VIDEO/AUX, CD, MD). Playback of the inserted disc or
tape begins, or the previously tuned station is received (Direct
Play Function).
pOWER is also available.
m
When the power is turned on, the disc compartment may open
and close to reset the unit.
To
turn the power off
Press POWER.
Flash window
The window on the top of the unit and the cassette decks light
up or flash while the unit is being powered on.
To turn off the light of the top window, press
■ while pressing
CD. To turn back on, repeat the above.
To turn off the light of the cassette decks, press
■ while pressing
TAPE. To turn back on, repeat the above.
To
change the brightness level of the display
1
2
3
Press~CO so th;t ‘rECO MODE is displayed. -
Within 4 seconds, turn MULTI JOG to display “DIM MODE,
and then press ENTER within 4 seconds.
Within 4 seconds, turn MULTI JOG to select the dimmer mode
as below.
The mode will be automatically set after 4 seconds. It will
also be set if ENTER is pressed within 4 seconds after step
3.
DIM-OFF ~DIMMER 1 u DIMMER 2~DlMMER 3
DIM-OFF: The normal display.
DIMMER
1:The illumination of the display is dimmer than
usual.
DIMMER 2: The illumination of the display is dimmer than
DIMMER 1.
DIMMER 3: The illumination of the display is dimmer than
DIMMER 2. The spectrum analyzer, the window on the top of
the unit, and the button lamps light off.
If the timer recording (page 27) is done with the economizing
mode (page 7) set to “ON” and the power turns off, the dimmer
mode will be set to “DIMMER 3“ the next time the power is
turned on.
6 ENGLISH