Filter
Top Products
A microphone (not supplied) can be connected to this unit,
allowing you to sing along to music sources.
Use a microphone with mini plugs (03.5 mm,
‘/8 inch).
1
2
3
4
Connect your microphone to MIC jack.
MIC
Press one of the function buttons to select
source to be mixed, and play the source.
Adjust the volume and tone of the source.
the
Turn MIC MIXING control to adjust the
microphone volume,
To record microphone sound mixed with source sound
Follow the procedure for recording from the sound source (see
page 20).
SYNC DUB cannot be used for mixing recording.
When not using the microphone
Turn MIC MIXING control to MIN and remove the microphone
from MIC jack.
“ If a microphone is held too near the speakers, a howling sound
may be produced. In this case, hold the microphone away from
the speakers, or decrease the microphone volume.
● If sound through the microphone is extremely loud, it may be
distorted. In this case, decrease the microphone volume.
QWhen the function is changed, the microphone volume and the
echo volume are set to off.
Recommended microphone
The use of unidirectional type microphone is recommended to
prevent howling. Contact your local Aiwa dealer for details.
wmwm*ek.*=.*$-.*--::-&:.&-:-%-wr.w.-:4=s# :*.=* :::-$,.--i s%n!?.wm r:=~sw~lam%s,+w~f W%sw.%ww%!!
VOCAL FADEFUMULTIPLEX FUNCTIONS
This unit can use discs or tapes as Karaoke sources.
Use the vocal fader function for ordinary discs or tapes.
Use the multiplex function for multi audio discs or tapes.
Press KARAOKE repeatedly to select the vocal fader or
multiplex function.
Each time KARAOKE is pressed, one of these functions is
The singer’s voice becomes softer than the accompaniment.
@ Auto Vocal Fader
The singer’s voice becomes softer only while there is audio
input through a microphone.
@
Multiplex
Only the sound on the left channel is heard from both speakers,
and the sound on the right channel is muted.
@ Auto Multiplex
The sound on the left channel is heard from both speakers,
and the sound on the right channel is muted only while there
is audio input through a microphone.
@
Cancel
To change the time lag setting in Auto Vocal Fader or
Auto Multiplex function
The muted singer’s voice can be restored faster.
When Auto Vocal Fader or Auto Multiplex is selected, “A-VF or
“A-MPX is displayed for 3 seconds and changes to the selected
function name. After the selected function name is displayed,
keep R
ressina KARAOKE until FAST is displayed.
To return to the initial setting, select SLOW.
When the power is turned off, SLOW is restored.
To change the audible channel in Multiplex function
When Multiplex is selected, ‘[MPX -U’ is displayed for 3 seconds
and changes to the selected function name. After the selected
function name is displayed, keep pressing KARAOKE until MPX-
R is displayed.
To return to the initial setting, select MPX-L.
When the power is turned off, MPX-L is restored.
● The Karaoke functions may not operate correctly with the
following kinds of CDs or tapes.
- Those with monaural sound
- Those recorded with strong echoes
- Those with the vocal part recorded on the right or left side of
the sound width
● While the Karaoke function is on, the sound is output as
monaural.
● When the function is changed, the Karaoke function is canceled.
24 ENGLISH