Filter
Top Products
18
Playing a tape
You can play any type of tape, TYPE I
(normal), TYPE II (CrO2) or TYPE IV (metal).
The deck automatically detects the tape type.
2 Press FUNCTION repeatedly until
“TC” appears.
3 Press DIR MODE on the remote
repeatedly to select to play one
side or * to play both sides.
4 Press · (or TAPE ª· on the
remote).
Press ª (or TAPE ª· on the remote
again) to play the reverse side. The tape
starts playing.
To
Stop play
Pause
Fast-forward
Find the beginning
of the current or
succeeding track
Remove
the cassette
Adjust the volume
1 Press § PUSH of the front cover
and insert a recorded tape into deck.
With the side you want
to play facing forward
Tips
•Pressing TAPE ª· on the remote while the
power is off automatically turns on the power and
starts tape playback if there is a tape in the deck
(One Touch Play).
•You can switch from another source to the tape
deck just by pressing TAPE ª· on the remote
(Automatic Source Selection).
•When you want to reduce the hiss noise in low-
level high-frequency signals, press DOLBY NR on
the remote before step 4 so “a” appears.
4
p
P
º/‚
3
VOL+/–
≠/±
DOLBY NR
1/u
(Power)
4
π
∏
2
≠º/
‚±
1
VOLUME
+/–
or rewind
* The deck stops automatically after playing both
sides five times.
Do this
Press π.
Press ∏. Press again to
resume play.
During stop press ‚ ‚±
or ≠º (or º/‚ on
the remote).
During play, press ≠º
or ‚± (or ≠/±
on the remote).
Press § PUSH.
Press VOLUME +/– (or
VOL +/– on the remote).
1/u
(Power)