Filter
Top Products
15
Basic Operations
To Do this
Turn off the radio Press 1/u.
Adjust the volume Press VOLUME +/– (or
VOL +/– on the remote).
To listen to non-preset radio
stations
Press TUNING/PLAY MODE on the remote
repeatedly in step 3 until “MANUAL”
appears, then press TUNING +/– (or
≠/± on the remote) to tune in the
desired station.
Tips
•Pressing TUNER/BAND on the remote while the
power is off automatically turns on the power and
tunes to the last received station (One Touch Play).
•You can switch from another source to the radio
just by pressing TUNER/BAND on the remote
(Automatic Source Selection).
•If an FM program is noisy, press STEREO/
MONO on the remote repeatedly until “MONO”
appears. There will be no stereo effect, but the
reception will improve. Press this button again to
restore the stereo effect.
•To improve broadcast reception, remove the rear
cover and put the antenna out of the cabinet (See
“To remove the AM antenna” on the page 6 ).
Preset
number
Frequency
TUNED
PRESET
MHz
ST
Listening to the radio
— Preset Tuning
Before using this function, preset radio
stations in the tuner’s memory (see “Step
3: Presetting radio stations”).
1 Press FUNCTION repeatedly until
“FM” or “AM” appears.
2 Press FM or AM (or TUNER/BAND
on the remote repeatedly).
3 Press TUNING/PLAY MODE on
the remote repeatedly until
“PRESET” appears.
4 Press TUNING +/– (or ≠/±
on the remote) to tune in the desired
preset station.
1/u
(Power)
4
3
VOL
+/–
STEREO/
MONO
2
2
VOLUME
+/–
4
1
1/u
(Power)