Filter
Top Products
Tuner
37
GB
To change the AM tuning interval
(except for European model)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding L,
press ?/1 on the unit. When you change the
interval, all the AM preset stations are erased.
To reset the interval, tune in any AM station
first, then turn off the system. While holding FM
MODE, press ?/1 on the unit.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for about a day even
if you disconnect the mains lead or if a power failure
occurs.
• You can label the preset stations (page 38).
• To improve the reception, adjust the supplied aerials
or connect an external aerial.
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 36).
1 Press TUNER BAND repeatedly to
select “FM” or “AM”.
2 Press TUNING MODE repeatedly until
“PRESET” appears in the display.
3 Press + or – repeatedly to select the
desired preset station.
To select the desired preset
number using the number buttons
Press number buttons instead of performing step
3. To enter preset number 10 or higher, press
>10 followed by the number button for the one’s
digit. To enter 0, press 10/0.
Listening to the radio
continued