Filter
Top Products
40
GB
BDV-EF1100
4-446-737-11(1)
D:\NORM'S JOB\SONY HA\SO120045\BDV-EF1100\4446737111_GB
(CEK)\080OTH.fm
masterpage: Left
Deactivating the
Buttons on the Unit
(Child Lock)
You can deactivate the buttons on the unit
(except for "/1) for preventing
misoperation, such as child mischief.
Hold down x on the unit for more
than 5 seconds.
“LOCKED” appears in the front panel
display.
The child lock function is activated and the
buttons on the unit are locked. (You can
operate the system by using the remote
control.)
To cancel, hold down x for more than
5 seconds until “UNLOCK” appears in the
front panel display.
If you operate the buttons on the unit while the
child lock function is on, “LOCKED” flashes in
the front panel display.
Controlling Your TV
with the Supplied
Remote Control
By adjusting the remote control signal, you
can control your TV with the supplied
remote control.
When you replace the batteries of the remote
control, the code number may reset to the default
(SONY) setting. Set the appropriate code number
again.
While holding down TV "/1, press
number buttons to enter your TV’s
manufacturer’s code (see the table).
Then release TV "/1.
If the setting is unsuccessful, the currently
registered code is not changed. Re-enter the
code number.
If more than one code number is listed, try
entering them one at a time until you find
the code that works with your TV.
Saving Power in
Standby Mode
Check that you have made the following
settings:
– [Control for HDMI] in [HDMI Settings]
is set to [Off] (page 47).
– [Quick Start Mode] is set to [Off]
(page 48).
– [Remote Start] in [Network Settings] is
set to [Off] (page 49).
Note
Note
Preparing the remote
control for controlling
the TV
Manufacturer Code number
SONY 01 (default)
LG 05
PANASONIC 06
PHILIPS 02, 03, 07
SAMSUNG 02, 08
TOSHIBA 04