Filter
Top Products
Removing the Library from the Rack
15
3
Press the locking arm to release the lock, and then
slide the library all of the way into the rack.
4
Hand tighten the screw on one of the L-shaped
brackets on the front of the rack so that the library
is secured in place.
5
Hand tighten the screw on the other L-shaped
bracket the same manner.
6
Confirm that the library is housed properly in the
rack.
Once the library is mounted in the rack, connect the
power cord and the SCSI cables and make all
necessary settings as described in the Quick Start
Guide and Operating Instructions (PDF).
Removing the Library
from the Rack
Caution
With a single drive installed, the S-AIT library weighs
approximately 27 kg/59.5 lbs. (With two drives
installed, the S-AIT library weighs approximately
31 kg/68.3 lbs.)
At least two people are needed in order to handle the
library. Handling the S-AIT library on your own could
result in back injury or other accidents resulting in injury
or damage to the S-AIT library.
1
Turn off the library.
To turn the power off, press the rear power switch.
2
Disconnect all of the cables.
3
Loosen the screws in both of the L-shaped brackets.
4
Pull the library out of the rack.
5
If necessary, remove the rail assemblies and
brackets from the rack.
6
If necessary, remove the inner rails and L-shaped
brackets from the library.
Locking arm
Fastener