Filter
Top Products
Preparation
11
Preparation
In order to mount the S-AIT library, first mount the rails
and brackets on the library and rack.
Before beginning work, always be sure to turn off the S-
AIT library, and then disconnect all cables.
Pull Out the Inner Rails
Pull out the inner rails from the rail assemblies.
1
Pull out the inner rail from one of the rail
assemblies as far as it will go.
The rail can be extended until the locking arm on
the back of the rail emerges.
2
Turn the rail assembly over. Press the locking arm
to release the lock, and then pull the inner rail all of
the way out.
3
Repeat the process with the other rail assembly,
pulling out its inner rail.
Note
The inner rail will be mounted on the S-AIT library,
while the rail assembly will be mounted on the rack.
Preparing the Library
Mount the L-shaped brackets and inner rails on the
library.
Caution
• Electrostatic charges that build up on your body can
damage the components. Before starting work, touch
the metal chassis of the S-AIT Library.
• Do not touch any components other than those that
must be replaced. In the event of damage, a charge will
be assessed for repair.
Mounting the L-shaped Brackets
1
Use two A screws to mount an L-shaped bracket on
the side of the library as shown in the diagram.
2
Mount the L-shaped bracket on the other side of the
library in the same manner.
Mounting the Inner Rails
1
Use four A screws to mount an inner rail on the
library.
2
Mount the other inner rail on the other side of the
library in the same fashion.
Back of rail assembly
Locking arm
Rail assembly
Inner rail
Inner rail
A screw
Position of screw hole on the left side