Filter
Top Products
Preparation
13
Mounting the Rail Assemblies on the
Brackets
1
Place a rail assembly in one set of brackets, slide the
rail assembly all of the way into the rack (1), and
then pull the slide rail out of the rail assembly (2).
Note
If the rail comes in contact with the rack and does
not slide in and out smoothly, install the rail guides.
For information about how to install the rail guides,
see “When the Rack Obstructs Rail Movement”
(page 14).
2
Align the screw holes in the rail assembly with the
screw holes in the brackets, and then use a C screw
to secure the back end of the rail assembly to the
bracket.
When you use the S screw holes you do not need to
use nuts, so installation is easier. If you cannot use
the S screw holes, secure the screws with nuts.
The position is easy to determine if you push the
rail assembly all of the way into the rack so that it
is touching the post in the back of the rack. If the
screw holes do not line up, use the slot to the side of
the round screw hole to fasten the rail assembly to
the bracket. If you decide to use the elongated holes
to fasten the rail assembly to the bracket, you must
fasten the rail assembly in two points. If you fasten
the rail assembly in only one point, the rail
assembly can turn on the bracket, which may lead
to damage and/or injury when pulling out the
S-AIT library from the rack.
3
Pull the slide rail all of the way out of the rail
assembly, and then use a C screw to secure the front
end of the rail assembly to the bracket.
If you decide to use the elongated holes to fasten the
rail assembly to the bracket, you must fasten the rail
assembly in two points. If you fasten the rail
assembly in only one point, the rail assembly can
turn on the bracket, which may lead to damage and/
or injury when pulling out the S-AIT library from
the rack.
If you use the slots for fastening, be sure to
carefully align the rack and the rail assembly before
tightening the screws.
4
Mount the rail assembly on the other side in the
same manner.
Rail assembly
Bracket
Slide rail
(1)
(2)
Use this slot if the
screw holes do not
line up.
C screw
Rail assembly flush
against rack post
S screw hole
S screw hole