Filter
Top Products
38
GB
Listening to FM/AM radio
You can listen to FM and AM broadcasts
through the built-in tuner. Before operation,
make sure you have connected the FM and
AM antennas (aerials) to the receiver (page
29).
Tip
The tuning scale for direct tuning differs depending
on the area code as shown in the following table. For
details on area codes, see page 5.
* The AM tuning scale can be changed (page 39).
1 Press TUNER repeatedly to
select the FM or AM band.
2 Press TUNING + or TUNING –.
Press TUNING + to scan from low to
high; press TUNING – to scan from high
to low.
The receiver stops scanning whenever a
station is received.
Using the controls on the
receiver
1 Turn INPUT SELECTOR to select the FM
or AM band.
2 Press TUNING MODE repeatedly to select
“AUTO”.
3 Press TUNING + or TUNING –.
In case of poor FM stereo
reception
If the FM stereo reception is poor and “ST”
flashes on the display, select monaural audio
so that the sound will be less distorted.
1 Press AMP MENU.
2 Press V/v repeatedly to select “TUNER”,
then press or b.
3 Press V/v repeatedly to select
“FM MODE”, then press or b.
4 Press V/v repeatedly to select “MONO”,
then press .
5 To return to stereo mode, repeat steps 1 to 4
and select “STEREO” in step 4.
Tuner Operations
Area code FM AM
U2, CA2 100 kHz 10 kHz*
ECE, CEK, AU1 50 kHz 9 kHz
.
mM
>
X
x
BD DVD
SAT/
CATV
VIDEO
SA-CD/
CD
DMPORT
TUNER
O
TV
MENU
TUNING
+/–
Numeric
buttons
SHIFT
ENTER
D. TUNING
TUNER
,
V/v/B/b
AMP
MENU
Tuning into a station
automatically (Automatic
Tuning)