Filter
Top Products
17
GB
Connections
Inserting batteries into the
remote
Insert two R6 (size-AA) batteries in the
RM-AAU071 (Models of area code U2, CA2
only) or RM-AAU074 (Models of area code
ECE, CEK, AU1 only) Remote Commander.
Observe the correct polarity when installing
batteries.
Notes
•Do not leave the remote in an extremely hot or
humid place.
•Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
•Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
•If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
•When you replace the batteries, the remote buttons
may be reset to their initial settings. If this happens,
reassign the buttons again (page 66).
•When the remote no longer operates the receiver,
replace all the batteries with new ones.
1: Installing the speakers
This receiver allows you to use a 5.1 channel
system (5 speakers and one subwoofer).
To fully enjoy theater-like multi channel
surround sound requires five speakers (two
front speakers, a center speaker, and two
surround speakers) and a subwoofer (5.1
channel).
Example of a 5.1 channel
speaker system configuration
AFront speaker (Left)
BFront speaker (Right)
CCenter speaker
DSurround speaker (Left)
ESurround speaker (Right)
FSubwoofer
Connections
continued