Filter
Top Products
37
GB
Basic Operations
Using the Sleep Timer
You can set the receiver to turn off
automatically at a specified time.
1 Press AMP MENU.
2 Press V/v repeatedly to select
“SYSTEM”, then press or b.
3 Press V/v repeatedly to select
“SLEEP”, then press or b.
4 Press V/v repeatedly to select
the preset time you want, then
press .
The display changes as follows:
OFF y 0-30-00 y 1-00-00 y
1-30-00 y 2-00-00
When sleep timer is being used, “SLEEP”
indicator lights up in the display.
Note
A count down is displayed 1 minute before the
receiver turns off.
Tip
To check the remaining time before the receiver
turns off, repeat step 1 to 3 above. The remaining
time appears on the display.
Recording
You can record from a video/audio component
using the receiver. Refer to the operating
instructions supplied with your recording
component.
1 Press one of the input buttons
to select the playback
component.
You can also use INPUT SELECTOR on
the receiver.
2 Prepare the playback
component for playing.
For example, insert the video tape you
want to copy into the VCR.
3 Prepare the recording
component.
Insert a blank video tape, etc. into the
recording component (VIDEO) for
recording.
4 Start recording on the
recording component, then
start playback on the playback
component.
Notes
•Some sources contain copy guards to prevent
recording. In this case, you may not be able to
record from the source.
•Only analog signals are output from the analog
output jack (for recording).
•HDMI sound cannot be recorded.
O
MENU
,
V/v/B/b
AMP
MENU
Recording onto a recording
media