Filter
Top Products
13
SONAMP
®
ASAP3D SE STEREO POWER AMPLIFIER
Appendix 1: Changing the Mono Variable Output to a Fixed Output Level
The M
ONO VAR OUT is factory-set to
Variable
via a jumper on the amplifier PCB. To change the output to a fixed level (which
is not affected by the front-panel L and R Input Level Controls or by IR volume commands):
1. Unplug the amplifier’s power cord from the Power Cord Connection on the back of the amplifier.
2. Remove the 8 screws (4 on top and 2 on each side) that secure the amp’s chassis cover.
3. Locate the M
ONO OUT section on the circuit board (see
Figure 27
).
4. Remove the jumper from the center pin and the “V” (variable) pin and re-insert it between the center pin and the “F” (fixed)
pin (see
Figure 28
).
5. Replace the amplifier’s chassis cover and screws, and plug the power cord back into the Power Cord Connection.
Appendix 2: IR Command List
The following ASAP3D SE functions can be controlled via IR:
Variable
Jumper Jumper
Fixed
Front
Panel
M
ONO
O
UT
Jumper
FIGURE 27: MONO OUT JUMPER LOCATION
FIGURE 28: CHANGING THE JUMPER FROM
F
IXED
TO
V
ARIABLE
• Amplifier ON (Local source active)
• Amplifier OFF (House source active)
• Mute ON
• Mute OFF
• Mute Toggle ON/OFF
• Volume –1 (Down one step)
• Volume +1 (Up one step)
• Volume –3 (Down three steps)
• Volume +3 (Up three steps)
• Volume –5 (Down five steps)
• Volume +5 (Up five steps)
• Volume 0 (Jump to 0)
• Volume 20 (Jump to 20)
• Volume 40 (Jump to 40)
• Volume 60 (Jump to 60)
• Volume 80 (Jump to 80)
• Volume 100 (Jump to 100)
• BBE ON
• BBE OFF
• BBE Toggle ON/OFF