Filter
Top Products
25
UUssiinngg tthhee OOSSDD
CURRENT STATUS DISPLAY
This mode shows the status corresponding to each operation.
The on-screen display will automatically disappear in 5 seconds.
For example, there are 2 status displays as follows.
When selecting the desired input source. When selecting the TEST TONE mode.
This unit incorporates an OSD(On-screen display) function to provide information about basic operation of this unit and to
simplify the set-up procedures.
The OSD function uses a monitor TV connected to this unit as a display and has two kinds of display modes; Current Status
Display and Menu Screen.
Notes:
Any on-screen display shown on the monitor TV will not be recorded onto VIDEO 1.
In some countries, this unit allows you to select either NTSC or PAL color system as your video format.
If it is different from your video components and video software, etc., while in the standby mode, press the STANDBY
button while keeping the CHECK button pressed on the front panel, then the video format will change to the NTSC or the
PAL color system.
However, in some countries, only the NTSC system is available.
MENU SCREEN
This function simplifies the set-up procedures for items such as the speaker mode, function select, surround
mode, delay time and channel level trim.
The menu screen operation is performed easily with the CURSOR control(, , , ), ON SCREEN
DISPLAY and ENTER buttons.
VIDEO 1 (OPTICAL 1)
Input source Signal input
FL
----------------- -------------------
0
(( ))
FL C FR
SW
RL RR
Channel level or overall volume display
The main menu will be shown.
To turn the menu screen off, press this button,
again.
In the button of the display, “up” stands for the CURSOR
UP() button. “down” for the CURSOR DOWN(),
“OSD” for the ON SCREEN DISPLAY and “ENTER” for
the ENTER button.
POWER P.SCAN
DECK
DISPLAY
SLEEP
T.TONE
D.TIME
ADJUST
AUTO DSP MODE
12345
67890
STEREO
A
B
SYS
CD
ENTEROSD
INTROREPEAT
DISC
A B
<
<
CD
TUNERVIDEO
PRESET
USER FILET.MONDISPLAY
AUX
TAPE MON.
EQUALIZER
INPUT
SELECTOR
6CH DIRECT
CH LEVEL MASTER
MUTE
CH SEL.
DECK SEL.
OSD
MAIN MENU
Main menu display
up/down : MOVE
OSD : END ENTER : SELECT
SPEAKER MODE
FUNCTION SELECT
SURROUND MODE
DELAY TIME
CH LEVEL TRIM
When adjusting each channel level or overall volume, the
volume level display will be shown.
The test tone display will be shown until the test tone mode
is canceled.
Turn the menu screen on.
1
EENNGGLLIISSHH