Filter
Top Products
EENNGGLLIISSHH
12
Operate the selected component for
playback.
5
Enter the tone mode.
7
Select the digital or the analog input
connected as desired.
4
Each time this button is pressed, the tone mode
changes as follows:
TONE OFF: When listening to a pure program source
without the tone effect.
TONE ON: When adjusting the tone for your
taste.
When “TONE OFF” is selected.
The tone direct function is activated and the sound
that bypasses the tone circuitry will be heard.
To cancel the tone direct function, select “TONE
ON” performing the above steps 7 and 8.
When “TONE ON” is selected.
1) Select the tone mode as desired.
Each time this button is pressed, the mode changes
as follows;
BASS TRBL(treble) TONE ON
2) At the desired tone, adjust as desired.
In general, we recommend the bass and the treble to
be set to 0(flat) level.
To complete tone adjustment, repeat the above steps
1) and 2).
Notes:
If the tone display disappears, start from the step 7
again.
Extreme settings of the tone controls at high volume
may damage your speakers.
In DTS or Dolby Digital mode, the tone controls
cannot be adjusted and the tone direct function is
activated automatically.
“TONE ON” or “TONE OFF” is shown for 5
seconds.
To play back the program sources in surround sound,
refer to “ENJOYING SURROUND SOUND” on
page 16.
Adjust the(overall) volume.
6
Select the tone mode as desired.
8
WWhheenn CCDD,, VVIIDDEEOO 11~~VVIIDDEEOO 44 iiss sseelleecctteedd
aass aann iinnppuutt ssoouurrccee
AAddjjuussttiinngg tthhee ttoonnee ((bbaassss aanndd ttrreebbllee))
Each time this button is pressed, the corresponding
input is selected as follows;
o(ptical) 1 o(ptical) 2
A(nalog) c(oaxial) 2 c(oaxial) 1
To listen to DTS or Dolby Digital program source in
the 2-CH downmix mode(the stereo mode), the
corresponding digital input should be selected. (For
details, refer to “Downmixing into 2 front channels”
on page 19.)
Notes:
When the selected optical or coaxial digital input is
not connected, the selected DIGITAL INPUT
indicator flickers meaning no sound. (Refer to
“ENJOYING SURROUND SOUND” on page 16.)
The sound from the component connected to the
selected digital input can be heard regardless of the
selected input source.
DIGITAL
INPUTS
TONE MODE
TONE MODE
ADJUST
ADJUST
POWER P.SCAN
DECK
DISPLAY
SLEEP
T.TONE
D.TIME
ADJUST
AUTO DSP MODE
12345
67890
STEREO
A
B
SYS
CD
ENTEROSD
INTROREPEAT
DISC
A B
<
<
CD
TUNERVIDEO
PRESET
USER FILET.MONDISPLAY
AUX
TAPE MON.
EQUALIZER
INPUT
SELECTOR
6CH DIRECT
CH LEVEL MASTER
MUTE
CH SEL.
DECK SEL.
or
MASTER VOLUME
DOWN UP
MASTER