Filter
Top Products
ENGLISH
48
SETTING THE CH LEVEL
Note :
• Depending on the speaker settings("N" (None or No)), some channels cannot be selected.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory("CAL"),
not into preset memory("REF 1", "REF 2").
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit
your tastes.(For details, refer to "Adjusting each channel level with test tone" on page 23.)
Adjusting the current channel level
1. Press the CURSOR UP()/DOWN() buttons to select the desired channel.
2. Press the CURSOR LEFT()/RIGHT() buttons to adjust the level of the selected channel or program sources LFE as
desired.
• The LFE level can be adjusted within the range of -10 ~ 0
dB and other channel levels within the range of -15 ~ +15
dB.
• In general, we recommend the LFE level to be adjusted
to 0 dB.(However, the recommended LFE level for some
early DTS software is -10 dB.) If the recommended levels
seem too high, lower setting as necessary.
Example) When selecting Dolby Digital source’s LFE.
3. Repeat the above steps 1 and 2 to adjust each channel level.
7
0
DISPLAY
SEL SEL
P.SCAN
CH.LEVEL
MUTE
D/A MODE
SETUP
TONE
SOUND
PARAMETER
ENTER
VOLUME
VIDEO 1TAPE VIDEO 2 VIDEO 3
EXT.IN
CD
FM/AM/XM
AUX
T
E
S
T
S
T
E
R
E
O
S
U
R
R
O
U
N
D
S
E
A
R
C
H
M
O
D
E
CH LEVEL
MODE : CAL / REF 1 / REF 2 Memory mode
FL : 0 dB / -15~+15
C : 0 dB / -15~+15
FR : 0 dB / -15~+15
SR : 0 dB / -15~+15
BR : 0 dB / -15~+15
BL : 0 dB / -15~+15
SL : 0 dB / -15~+15
SW : 0 dB / -15~+15
DD : 0 dB / -10~0
DTS: 0 dB / -10~0
RETURN
7
8
0
9
DISPLAY
SEL SEL
P.SCAN
CH.LEVEL
MUTE
D/A MODE
SETUP
TONE
SOUND
PARAMETER
ENTER
VOLUME
VIDEO 1TAPE VIDEO 2 VIDEO 3
EXT.IN
CD
FM/AM/XM
AUX
T
E
S
T
S
T
E
R
E
O
S
U
R
R
O
U
N
D
S
E
A
R
C
H
M
O
D
E