Filter
Top Products
ENGLISH
22
Continued
• Depending on the surround mode, each time these buttons are
pressed, the parameter mode changes as follows:
* When listening in Dolby Pro Logic II/Dolby Pro Logic IIx Music mode, you
can adjust the various surround parameters for optimum surround effect.
“PANO” “C.WIDTH” “DIMEN”
(Panorama mode) (Center width control) (Dimension control)
* When listening in Dolby Virtual Speaker mode, you can select the speaker
layout to be used actually for each Dolby Virtual Speaker mode.
REF WIDE
(Dolby VS Reference mode) (Dolby VS Wide mode)
* When listening in Dolby Headphone mode, you can select the desired
listening mode for each Dolby Headphone mode.
DH 1 DH 2 DH 3
(Dolby Headphone 1 mode)
2. Press the CURSOR UP()/DOWN() buttons to select the desired parameter.
When selecting the “NIGHT” (Night mode)
This function compresses the dynamic range of previously specified parts of the Dolby Digital or DTS sound track (with
extremely high volume) to minimize the difference in volume between the specified and non specified parts.
This makes it easy to hear all of the sound track when watching movies at night at low levels.
The night mode can be set in 11 steps from 0.0 to 1.0 (default value : 0.0)
Note: In some Dolby Digital or DTS softwares, the night mode may not be valid.
[Dolby Pro Logic II/Dolby Pro Logic IIx Music Parameters]
When selecting the “PANO” (Panorama) mode
This mode extends the front stereo image to include the surround speakers for an exciting “wraparound” effect with side wall
imaging. Select “OFF” or “ON” (default value : OFF).
When selecting the “C.WIDTH” (Center width) control
This adjusts the center image so it may be heard only from the center speaker, only from the left/right speakers as a phantom
image, or from all three front speakers to varying degrees.
The control can be set it 8 steps from 0 to 7 (default value : 3).
When selecting the “DIMEN” (Dimension) control
This gradually adjusts the soundfield either towards the front or towards the rear. The control can be set in 7 steps from -3 to +3
(default value : 0).
[Dolby Virtual Speaker Parameters]
When selecting the “REF” (Dolby Virtual Speaker Reference) mode
2 SP : When using 2 front speakers only.
3 SP : When using 2 front and center speakers.
3. Press the CURSOR LEFT()/RIGHT() buttons to adjust the selected parameter as desired.
7
8
0
9
DISPLAY
SEL SEL
P.SCAN
CH.LEVEL
MUTE
D/A MODE
SETUP
TONE
SOUND
PARAMETER
ENTER
VOLUME
VIDEO 1TAPE VIDEO 2 VIDEO 3
EXT.IN
CD
FM/AM/XM
AUX
T
E
S
T
S
T
E
R
E
O
S
U
R
R
O
U
N
D
S
E
A
R
C
H
M
O
D
E
7
8
0
9
DISPLAY
SEL SEL
P.SCAN
CH.LEVEL
MUTE
D/A MODE
SETUP
TONE
SOUND
PARAMETER
ENTER
VOLUME
VIDEO 1TAPE VIDEO 2 VIDEO 3
EXT.IN
CD
FM/AM/XM
AUX
T
E
S
T
S
T
E
R
E
O
S
U
R
R
O
U
N
D
S
E
A
R
C
H
M
O
D
E