Filter
Top Products
ENGLISH
40
When selecting the VIDEO MODE
• You can select the video input signal to be output from the MONITOR OUTs other than the HDMI MONITOR OUT.
“AT” (AUTO) : When there are multiple video input signals, the video input signals are detected and the video input signal
to be output from the MONITOR OUTs is selected automatically in the following order : component video, S-
video, composite video.
“CPS” (COMPOSITE) : The signal that is input into the (COMPOSITE) VIDEO jack is always played. The composite video
input signal is up-converted and output from the S-VIDEO and COMPONENT MONITOR OUT jacks.
“SVD” (S-VIDEO) : The signal that is input into the S-VIDEO jack is always played. The S-video input signal is converted
and output from the (COMPOSITE) VIDEO and COMPONENT MONITOR OUT jacks.
“CPN” (COMPONENT) : The signals that are input into the COMPONENT jacks are always played.
Because video conversion is not performed, no video signals are output from the MONITOR OUT
jacks when there are no video signals that are input into the COMPONENT jacks.
• For details, refer to "Relationship between the video input signal and the video output signal" on page 7.
• Depending on how to select a surround mode, you can select the auto surround mode or the manual surround mode.
OFF : You can select the desired of different surround modes selectable for the signal being input with using
(Manual surround mode) the MULTI CONTROL knob or the SURROUND MODE UP/DOWN ( >/< ) buttons. (For details, refer to
"When selecting the manual surround mode with pressing the SURROUND MODE button on the front
panel" on page 20.)
ON : The optimum surround mode will be automatically selected depending on the signal format being input.
(Auto surround mode)
Notes :
• When the SPEAKER button is set to off, the auto surround mode is invalid.
• Even when the auto surround mode is selected and the same type of digital signal format is being input, the optimum surround
mode may vary depending on whether the speaker type is set to "N” (None) or not.
• When the auto surround mode is selected and the PCM (2 channel) digital signal or the analog stereo signal is being input,
only the stereo mode will be selected.
• When the auto surround mode is selected, the surround modes other than the optimum surround mode cannot be selected.
When selecting the AUTO SURROUND
• The remastering processes the input digital signal and converts its digital sampling frequency to twice the current frequency
(88.2/96 kHz) for a more detailed sound reproduction.
OFF : To turn off the remastering function.
ON : To process the input digital signal and to convert its sampling frequency to 88.2/96 kHz for a more detailed sound
reproduction.
Notes:
• The remastering function have no effect on the input digital signal from the 88.2/96 kHz source or higher as well as the digital
signal that is output from the OPTICAL DIGITAL OUT of this receiver.
• When playing an analog input source, the remastering function cannot be activated.
• There may be a slight time delay between the video and audio signals in case that some video playback equipments may
process the video signals later than the audio signals due to signal processing procedure, etc.. Should this happen, you can
adjust the time delay of audio signals to synchronize the sound with the picture.
• The time delay can be adjusted within the range of 0 ~ 200 msec.
When selecting the AV SYNC
When selecting the REMASTER
Continued