Filter
Top Products
45
4. Repeat the above steps 2 and 3 until the speakers are all set to the desired mode.
1. Press the CURSOR UP()/DOWN() buttons to select the “DISTANCE”, then press the ENTER button.
2. Press the CURSOR UP()/DOWN() buttons to select the desired item.
3. Press the CURSOR LEFT()/RIGHT() buttons to set the selected item as desired.
4. Repeat the above steps 2 and 3 until the distances are all set as desired .
Continued
About the speaker size
• Select “L” (Large) or “S” (Small) not according to the actual size of the speaker but according to the speaker's capacity for
playing low frequency (bass sound below frequency set on the SPEAKER CROSSOVER menu) signals.
• If you do not know, try comparing the sound at both settings (setting the volume to a level low enough so as not to damage
the speakers) to determine the proper setting.
• When setting the speaker size by performing the auto setup, depending on whether the measured crossover frequency of
each speaker is lower or higher than 80 Hz, its size is automatically set to “L" (Large) or “S" (Small). (For details, refer to
"When selecting the SPEAKER CROSSOVER" on page 46.)
When selecting the desired unit
• You can select either “M” (Meter) or “FT” (Feet).
• Once a unit is selected, the distances are automatically
changed in the selected unit.
When setting the distance
• You can set the distance within the range of 0.1 ~ 9.0
meters in 0.1 meter intervals (or 0 ~ 30 feet in 0.5 feet
intervals).
When selecting the SPEAKER DISTANCE
Note :
• You cannot select the subwoofer and the speakers set to
"N" (None).
About the speaker distance
When enjoying multi-channel surround playback with Dolby Digital and DTS sources, etc., it is ideal that the center, surround
and surround back speakers should be the same distance from the main listening position as the front speakers. By entering
the distance between the listening position and each speaker, the delay times of center, surround and surround back speakers
are automatically adjusted to create an ideal listening environment virtually as if the center, surround and surround back
speakers were at their ideal locations respectively.
7
0
DISPLAY
SEL SEL
P.SCAN
CH.LEVEL
MUTE
D/A MODE
SETUP
TONE
SOUND
PARAMETER
ENTER
VOLUME
VIDEO 1TAPE VIDEO 2 VIDEO 3
EXT.IN
CD
FM/AM/XM
AUX
T
E
S
T
S
T
E
R
E
O
S
U
R
R
O
U
N
D
S
E
A
R
C
H
M
O
D
E
7
0
DISPLAY
SEL SEL
P.SCAN
CH.LEVEL
MUTE
D/A MODE
SETUP
TONE
SOUND
PARAMETER
ENTER
VOLUME
VIDEO 1TAPE VIDEO 2 VIDEO 3
EXT.IN
CD
FM/AM/XM
AUX
T
E
S
T
S
T
E
R
E
O
S
U
R
R
O
U
N
D
S
E
A
R
C
H
M
O
D
E
7
8
0
9
DISPLAY
SEL SEL
P.SCAN
CH.LEVEL
MUTE
D/A MODE
SETUP
TONE
SOUND
PARAMETER
ENTER
VOLUME
VIDEO 1TAPE VIDEO 2 VIDEO 3
EXT.IN
CD
FM/AM/XM
AUX
T
E
S
T
S
T
E
R
E
O
S
U
R
R
O
U
N
D
S
E
A
R
C
H
M
O
D
E
ENTER
ENGLISH