Filter
Top Products
Appendix
-63
Info
• Do not touch the glass surface of the lamp
unit or the inside of the projector.
• To avoid injury to yourself and damage to
the lamp, make sure you carefully follow
the steps below.
• Do not loosen other screws except for the
lamp unit cover and lamp unit.
1
Press STANDBY/ON on the
projector or STANDBY on the
remote control to put the projec-
tor into standby mode.
2
Disconnect the power cord.
• Unplug the power cord from the AC
socket.
• Leave the lamp until it has fully cooled
down (about 1 hour).
3
Remove the lamp unit cover.
• Close the lens shutter. Loosen the user
service screw (1) that secures the lamp
unit cover. Remove the lamp unit cover
(2).
1
AC socket
STANDBY/ON button
AC socket
STANDBY/ON button
2
3
2
1
User service screw
(for lamp unit cover)
2
1
User service screw
(for lamp unit cover)
Removing and Installing the Lamp Unit
Warning!
• Do not remove the lamp unit from the projector right after use. The lamp and parts
around the lamp will be very hot and may cause burns or injury.
Lamp unit
AN-K15LP
Optional
accessory