Filter
Top Products
E-18
EN
Enhancing your system
The connection lead is not included. Purchase a commer-
cially available lead as shown below.
Audio cable (not supplied)
Portable audio
player, etc.
■ Listening to the playback sounds of
portable audio player, etc.
1
Use a connection lead to connect the portable audio
player, etc. to the AUDIO IN socket.
2 Press the ON/STANDBY button to turn the power on.
3 Press the AUDIO/LINE (INPUT) button (remote con-
trol) or FUNCTION button repeatedly (main unit) to
select AUDIO IN function.
4 Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, adjust the volume of the
connected device.
Note:
To prevent noise interference, place the unit away from
the television.
■ Headphones
● Do not set the volume on to maximum at switch on.
Excessive sound pressure from earphones and head-
phones can cause hearing loss.
● Before plugging in or unplugging the headphone, re-
duce the volume.
● Be sure your headphone has a 1/8” (3.5 mm) diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
● Plugging in the headphone disconnects the speakers au-
tomatically.
Troubleshooting chart
If something is wrong with this product, check the following
before calling your authorised SHARP dealer or service
centre.
■ General
Symptom Possible cause
●The clock is not set to
the correct time.
●A power failure occurred.
Reset the clock. (Refer
page 6)
●When a button is
pressed, the unit does
not respond.
●Set the unit to the power
standby mode and then
turn it back on.
●If the unit still
malfunctions, reset it.
(Refer page 19)
●No sound is heard. ●The volume level set to
“Min”.
●The headphones are not
connected.
●The speaker wires are not
connected.
●The unit is too far from the
Bluetooth stereo audio
source device.
●The unit is not paired with
the Bluetooth stereo audio
source device.
■ Remote control
Symptom Possible cause
●The remote control
does not operate.
●The AC power lead of the
unit is not plugged in.
●The battery polarity is
wrong.
●The battery is dead.
●The distance or angle is
incorrect.
●The remote control sensor
receives strong light.
■ Bluetooth
Symptom Possible cause
●No sound is heard. ●The unit is too far from the
Bluetooth stereo audio
source device.
●The unit is not paired with
the Bluetooth stereo audio
source device.
●Bluetooth sound
is interrupted or
distorted.
●The unit is too near to
a device that generates
electromagnetic radiation.
●There is an obstacle
between the unit and the
Bluetooth stereo audio
source device.
■ DAB/Tuner
Symptom Possible cause
●The radio makes
unusual noises
continuously.
●The unit placed near a TV
or computer.
●The FM/DAB aerial is not
placed properly. Move the
aerial away from the AC
power lead if it is located
nearby.