Filter
Top Products
E-15
Listening to the DAB+ (continued)
■ Selecting a station in the station list
Once a DAB+ station is received, you can select stations
in the station list.
1 Press the TUNER [DAB] button until “DAB” appears
on the display.
2 While receiving a DAB+ station, press the TUNING
( or ) to select the desired station.
Name of the current
station
The name of the station
being selected
3 Within 10 seconds, press the DAB ENTER button on
the remote control to tune into the desired station.
■ Manual tune
You can manually store stations which Auto Scan cannot
find. If reception is poor, you can adjust the sensitivity.
Manual tune is only available after Auto Scan. Perform
Auto Scan first.
1 Press the TUNER [DAB] button until “DAB” appears
on the display.
2 Press the DAB SCAN button
once.
3 Within 10 seconds, press the
TUNING ( or ) to select the
DAB+ frequency.
4 Within 10 seconds, press the
DAB ENTER button.
(G: Good,
B: Bad)
● Reception sensitivity appears. The percentage
number indicate the current level.
● If the level is too low, move the aerial or unit to
improve reception.
5 Press the DAB ENTER button again to store the sta-
tion and exit manual tune.
Note:
To erase all scanned stations, refer to “Factory reset,
clearing all memory” on page 19.
Changing the information display
You can switch DAB+ display information.
Press the DAB DISP button.
Each time the button is pressed, the information display
changes in the following order.
When “No Service” appears, the DAB DISP button does
not allow you to change the display.
[Station Name]
[Signal quality]
[Mode]
[Channel/Frequency]
[Scrolling text]
[Programme type]
[Multiplex name]
[Station Name]
Station name is displayed. (set by default)
[Scrolling text]
Information scrolls across the display when sent from the
station.
[Programme type]
A description of the type of content being broadcast by
the station.
[Multiplex name]
The name of the multiplex (ensemble) which provides the
current service.
[Channel/Frequency]
The DAB+ channel and frequency for the station.
(Frequency is displayed to two decimal places)
[Mode]
The data transfer speed and channel type (stereo or
mono) appear.
[Signal quality]
The signal quality is displayed as a number (0 - 100).
[85-100: Good, 70-84: Fair, 0-69: Poor]