Filter
Top Products
E-59
ENGLISH
SD-PX2
References
- Troubleshooting chart -
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a service tech-
nician.
If something is wrong with this product, check the following before calling your autho-
rized SHARP dealer or service center.
General
Tuner
Remote control
Symptom Possible cause Reference
page
No sound is heard. z Is the volume level set to "0"? P. 16
z Are the headphones connected? P. 55
z Are the speaker wires disconnect-
ed?
P. 11
The sounds from speakers
are not well balanced.
z Are the speaker wires connected to
the wrong channels?
P. 11
Noise is heard during play-
back.
z Move the unit away from any com-
puters or mobile phones.
When a button is pressed,
the unit does not respond.
z Set this unit to the power stand-by
mode and then turn it back on. If the
unit still malfunctions, reset it.
P. 60
Interference or noise occurs
on the TV image.
z Is the unit placed near TV with inter-
nal antenna? Use an outdoor anten-
na.
P. 12
Timer playback does not
start.
z Did you remove the plug from the
AC outlet, or did a power failure oc-
cur? Reset the clock and timer.
P. 15, 48
"CLOCK ADJUST" appears
when checking the clock.
z Did you remove the plug from the
AC outlet, or did a power failure oc-
cur? Reset the clock.
P. 15
The display on the unit is
dark.
z Is the display in the dimmer mode? P. 16
The display does not appear. z Is the sliding door open? P. 17
The power is not turned on. z Is the unit unplugged? P. 14
No images are displayed. z Is TV turned on? P. 51
z Is the input of TV switched? P. 51
Symptom Possible cause Reference
page
The radio makes unusual
noises continuously.
z Is the unit placed near the TV or
computer?
z Is the FM antenna or AM loop anten-
na placed properly? Move the an-
tenna away from the AC power cord
or the unit if located near.
P. 12
The preset channel cannot
be recalled.
z Did you remove the plug from the
AC outlet, or did a power failure oc-
cur?
P. 34
Preset the channel again.
Symptom Possible cause Reference
page
The remote control does not
operate properly.
z Is the battery polarity respected? P. 14
z Are the batteries dead?
z Is the distance or angle incorrect? P. 14
z Are there any obstructions in front of
the unit?
z Is the remote control sensor ex-
posed to strong light (inverter fluo-
rescent light, direct sunlight, etc.)?
P. 14
z Is the remote control for another
equipment used simultaneously?
The unit cannot be turned on
with the remote control.
z Is the AC power cord of the unit
plugged in?
P. 14
z Are the batteries inserted? P. 14