Filter
Top Products
E-56
ENGLISH
SD-PX2
Advanced Features
- Connecting other equipment -
Audio connection to TV
You can listen to TV sound from the speakers by connecting the unit using an optical
digital cable or audio cable (not supplied).
To listen to TV sound:
Turn the power on and press the TV button.
Each press of this button changes the input in the order of "AUTO" "DIGI-
TAL" "ANALOG".
Notes:
z Plug in each cable fully to prevent noise interference.
z Refer to the manual for the connected equipment.
z You can also use the FUNCTION button to set the input to TV.
Audio connection to VCR
You can listen to VCR sound from the speakers by connecting the unit using an audio
cable.
To listen to VCR sound:
Turn the power on and press the VCR button.
Notes:
z The audio VCR output jacks sends signals coming from a DVD/CD, the tuner,
audio TV input jacks, digital audio input jack, and digital audio TV input jack. Sig-
nals from the audio VCR input jacks are not sent.
z When sending signals coming from the digital audio input jack or digital audio TV
input jack via the audio VCR output jacks on the unit, set the stereo mode to "STE-
REO" (see page 38). In the multi channel mode, signals may not be sent properly.
When sending signals from the digital audio input jack to the audio VCR output
jacks, the audio output level decreases. (Leave headphones unplugged while
recording to avoid further level decrease.)
z Plug in each cable fully to prevent noise interference.
z Refer to the manual for the connected equipment.
z You can also use the FUNCTION button to set the input to "VCR".
Audio connection to a digital tuner
You can listen to sound from the digital tuner, etc. from the speakers by connecting
the unit using an audio digital cable.
To listen to the digital tuner:
Turn the power on and press the AUX button.
Notes:
z You can also listen to the digital tuner sound by connecting the tuner to the digital
audio TV input jack. Set the input to TV in this case.
z Plug in each cable fully to prevent noise interference.
z Refer to the manual for the connected equipment.
z You can also use the FUNCTION button to switch the input to auxiliary.
Using other subwoofer
You can connect a subwoofer with an amplifier to the subwoofer pre output jack.
Note:
No sound is heard from the speaker in which an amplifier is not built in.
Headphones
z Before plugging in or unplugging the headphones, reduce the volume.
z Be sure your headphones have a 1/8" (3.5 mm) diameter plug and are between 16
ohm and 50 ohm impedance. The recommended impedance is 32 ohms.
z While headphones are connected, sound is not produced from the speakers.
z You cannot use the surround feature with headphones.
z Do not plug in or unplug headphones while recording. The sound may skip.
AUTO: The audio input switches automatically. (*)
DIGITAL: The audio input is switched to digital.
ANALOG: The audio input is switched to analog.
(*) When digital and analog signals are received, the unit selects digital signals.