Sharp MD-M2H Stereo System User Manual


 
31
3
2
3
4
4
H
H
5
5
Recording from the built-in radio
onto a MiniDisc
1 Tune in to the desired station. (pages 16 - 17.)
2 Load a recordable MiniDisc.
3 Press the REC button.
The unit will enter the recording stand-by mode.
4 Check the recordable time by pressing the DIS-
PLAY button.
Note:
Before recording an AM broadcast, enter the
recording stand-by mode, and then separate the
AM loop aerial from the main unit. Adjust it so
that the AM broadcast can be tuned in most
clearly.
During recording, you cannot change the station.
5 Press the 0 6 button.
To stop recording:
Press the button.
The recording will stop and the track number will
be written on the MiniDisc.
Note:
It is not possible to pause in the recording mode.
To record the track number whilst record-
ing:
The recording is performed as a single track.
To identify different sections of a recording you can
increase the track number at any point during the
recording process.
To create a new track number, whilst in the record-
ing mode, press the REC button.
The track number will increase by one, and then
the recording will continue.
(Continued)