E-8
Placing the sound bar
Installation image:
Place
the
unit as
shown.
Notes:
As the sound from the speaker is omni-di-
rectional, you can place it anywhere you like.
However, it is recommended to place it as
close to the TV as possible.
The front panel of the unit is not removable.
Caution:
Do not change the installation direction when
the unit is turned on.
Do not stand or sit on the unit as you may be
injured.
●
●
●
●
TV
VCR
DVD player
Using other subwoofer■
You can connect a subwoofer with an amplier to
the SUBWOOFER PRE OUT socket.
Note:
No sound is heard from the subwoofer without a
built-in amplier.
Audio cable
(commercially
available)
Audio signal
To audio input
socket
Sound bar
To SUBWOOFER PRE
OUT socket
Commercially
available subwoofer
(amplier built in)
Falling prevention
Safety wires (not supplied) are use-
ful to prevent the unit from falling off
the table.
Loop the safety wires (not supplied)
into each hole as shown and tie the
safety wires to the LCD TV stand.
Sound bar connections to TVs
Caution:
Turn off all other equipment before making
any connections.
Tuner receiving for other audio system
Placing the antenna near the unit AC
power cord may cause noise pick up.
Place the antenna away from the unit for
better reception.
●
Notes:
To connect to TV, use either digital or
analog terminals located at the rear of
the unit.
Refer the operation manual of the equip-
ment to be connected.
Fully insert the plugs to avoid fuzzy pic-
tures or noises.
●
●
●