Filter
Top Products
E-11
General control
To turn the power on■
Press the ON/STAND-BY button.
The sound mode indicator and display light up.
Note:
If the power does not turn on, check whether
the power cord is plugged in properly.
To set the unit to stand-by mode:
Press the ON/STAND-BY button again.
Display brightness control■
Press the DIMMER button to adjust the brightness
of the display and sound mode indicator.
Sound mode indicator and display bright
Sound mode indicator and display dim
Sound mode indicator and display off. Pressing any
button will light up the display for 3 seconds only.
Volume auto fade-in■
If you turn off and on the unit with the volume set
to 40 or higher, the volume starts at 20 and fades
in to the last set level.
Volume control■
Unit operation:
Press volume up (VOL. + ) to increase the volume
and press volume down (VOL. – ) to decrease
the volume.
Remote control operation:
Press the VOLUME + button to increase the volume
and the VOLUME – button to decrease the volume.
00 01 02 ..... 59 60
Muting■
The volume is muted temporarily
when pressing the MUTE button
on the remote control. Press again
to restore the volume.
Preset sound mode■
Main unit operation:
To change to a different mode, press the SUR-
ROUND button repeatedly until the desired sound
mode lights up.
Remote control operation:
Press a desired sound mode on the remote control.
STANDARD
SPORT
CINEMA/GAME
NEWS
WOW HD is on for nominal effect
WOW HD on for cinema/game sound effect
WOW HD on for sport broadcasting
WOW HD on for news
WOW HD is on for nominal effect.
WOW HD on for cinema/game sound effect
WOW HD on for news
WOW HD on for sport broadcasting
STANDARD
CINEMA/GAME
NEWS
SPORT
Dolby Virtual Speaker
(DVS) sound mode
■
The Dolby Virtual Speaker (DVS) creates virtual
surrounds comparable to the 5.1ch sound produced
by the 2.1ch speaker. When setting DVS to “ON”
for 2 channel stereo signals, Dolby Pro Logic II
brings out virtual sound effects through the signals
converted into 5.1ch.
Press the DVS button.
The Dolby Virtual Speaker indicator lights up.
Notes:
Monaural signals do not generate surround ef-
fects.
DVS sound effect may not be obtained depend-
ing on signal types (the Dolby Virtual Speaker
indicator blinks). In this case, set the DVS mode
to “OFF”.
●
●