Filter
Top Products
E-14
Error indicators and
warnings
If problem occurs■
When this product is subjected to strong external
interference (mechanical shock, excessive static
electricity, abnormal supply voltage due to light-
ning, etc.) or if it is operated incorrectly, it may
malfunction.
If such a problem occurs, do the following:
Set the unit to the stand-by mode and turn the
power on again.
If the unit is not restored in the previous
operation, unplug and plug in the unit, and
then turn the power on.
1
2
(*): Should the same message appear even if the
unit is unplugged and plugged in or is set to the
stand-by mode and on again, contact your local
dealer where you purchased the unit.
The unit cannot be
turned on with the
remote control.
Is the AC power cord
of the unit plugged in?
Is the battery
inserted?
●
●
TV cannot be
operated with the
remote control.
Depending on the
model, some or all
functions may not be
operable using the
remote control of this
unit. In this case, use
the remote control
supplied with the TV.
●
Condensation■
Sudden temperature changes, storage or operation
in an extremely humid environment may cause con-
densation inside the cabinet or on the transmitter
on the remote control.
Condensation can cause the unit to malfunction.
If this happens, leave the power on until normal
operation is possible (about 1 hour). Wipe off any
condensation on the transmitter with a soft cloth
before operating the unit.
When you fail to perform operations properly, the
following messages are displayed on the unit.
Troubleshooting chart
(continued)
Symptom Possible cause
Display Meaning
or
or
Malfunction of the surround
circuit. Place the unit away
from noise source and plug
the AC power cord into
another AC outlet. (*)
●
or
(Display blinks
continuously)
When there is no input
signal. Play back the
connected equipment.
Nonstandard signal. Cannot
be recognized.
Signals other than DOLBY
DIGITAL, DTS, Linear PCM
cannot be recognized.
Poor connection of the
digital audio input terminal.
Turn off the unit and check
if the cable is connected
properly.
●
●
●
Power indica-
tor (blinks red)
When the protection circuit
is activated.
●
Factory reset, clearing all
setting
Make sure to disconnect all audio input cables
attached to the unit before performing the
factory reset.
1. Press the ON/STAND-BY button to enter the
power stand-by mode.
2. While pressing the SURROUND button, press
and hold the ON/STAND-BY button until “CL”
appears.
Caution:
This operation will erase all data stored in
memory.
■