Filter
Top Products
E-10
AC power connection
After checking all the connections have been made
correctly, connect the AC power cord to the AC power
input jack, then to the AC outlet.
Using with the AC/DC adaptor
■
1
Plug the AC power cord into the AC/DC adaptor.
2
Plug the AC/DC adaptor cable into the DC IN-
PUT jack on the unit.
3
Plug the AC power cord into an AC outlet.
Notes:
There will be no indication during power stand-
by mode unless the ON/STAND-BY button is
pressed.
Unplug the AC/DC adaptor from the AC outlet if the
unit will not be used for a prolonged period of time.
Use only the supplied AC/DC adaptor. Using other
AC/DC adaptor may cause an electric shock or
re.
●
●
●
RIGHT LEFT
LINE IN 1LINE IN 2
2
1
AC/DC Adaptor
Cable
DC IN jack
(DC 12V)
AC power cord
AC/DC Adaptor
AC outlet (AC 100 - 240 V ~ 50/60 Hz)
Remote control
Battery installation■
Insert pin into the hole as shown and pull to
open the battery holder.
1
Remove the old battery from the battery hold-
er, insert the new battery and then slide the
battery holder back into the remote control.
2
Back of
remote control
Pin
Battery type
Battery holder
Locking tab
Polarity (+) symbol
Positive (+) side up
Precautions for battery use:
Remove the battery if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
Caution:
Do not use rechargeable battery (nickel-cadmium
battery, etc.).
Danger of explosion if battery is incorrectly re-
placed.
Replace only with the same or equivalent type.
Batteries (battery pack or batteries installed) shall
not be exposed to excessive heat such as sun-
shine, re or the like.
Installing the battery incorrectly may cause the
unit to malfunction.
Notes concerning use:
Replace the battery if the operating distance is
reduced or if the operation becomes erratic. Pur-
chase “CR 2025”, coin lithium battery.
Periodically clean the transmitter on the remote
control and the sensor on the unit with a soft
cloth.
Exposing the sensor on the unit to strong light
may interfere with operation. Change the lighting
or the direction of the unit if this occurs.
Keep the remote control away from moisture,
heat, shock, and vibrations.
●
●
●
●
●
●
●
●
●
This product contains a CR Coin Lithium Battery
which contains Perchlorate Material – special
handling may apply, California residents, see
www.dtsc.ca.gov/hazardouswaste/perchlorate/
Caution:
If this product is to be used in other than 120 V region,
please change the AC power cord to suit the region.