Filter
Top Products
E-6
Controls and indicators (continued)
TV Operation Buttons (Only SHARP TV):
On/Stand-by
Button
Sets the TV power to
“ON” or “STAND-BY”.
Input Select Button
(TV)
Press the button to
switch the input source.
Volume Up and
Down Buttons
Turn up/down the TV
volume.
Channel Up and
Down Buttons
Switch up/down the TV
channels.
Note: ● Some models of SHARP TV may not be operable.
● SHARP TV remote control will not work with HT-SB350(BK) system.
Remote control
Plastic shield
Battery holder
Note:
Before using remote control, please remove plastic
shield at battery holder.
Make sure to unplug the AC power cord before
installing the unit or changing the position.
Select from three installation methods according
to the preferred position.
Using spikes
Nuts (secured on spikes) must be used when
installing spikes.
The unit can be levelled by adjusting the spikes
and nuts.
Option 2
Option 1
Tighten all spikes as shown
Notes:
Option 1 or option 2 indicates spike positions
based on LCD TV stand.
When attaching the spikes, place the unit on
a cushion or soft cloth to avoid damage.
Caution:
When using these spikes on glossy or slippery
table such as on glass top, stick foot cushions at
the bottom of the spikes to avoid slippage.
●
●
Note:
Option 1 or option 2 foot cushion positions based
on LCD TV stand.
To mount the unit on the wall
Caution:
Be very careful to prevent the unit [4.19 lbs. (1.90
kg)] from falling when mounting on the wall.
Before mounting, check the wall strength. (Do not
put on the veneer plaster or whitewashed wall. The
unit may fall.) If unsure, consult a qualied service
technician.
Mounting screws are not supplied. Use appropri-
ate ones.
Check all wall mount angle screws for looseness.
Select a good location. If not, accidents may occur
or the unit may get damaged.
SHARP is not responsible for accidents result-
ing from improper installation.
●
●
●
●
●
●
Using foot cushions
Option 1
Option 2
Attach foot cushions as shown
System preparation