Filter
Top Products
6
Make sure to unplug the AC power lead before in-
stalling the sound bar or changing the position.
Using spike legs
1 Peel the double sided tape separator.
2 Fix the spike leg onto the sound bar as
shown.
To mount the sound bar on the wall
Caution:
● Be very careful to prevent the sound bar [2.3 kg
(5.1 lbs.)] from falling when mounting on the wall.
● Before mounting, check the wall strength. (Do not
put on the veneer plaster or whitewashed wall. The
sound bar may fall.) If unsure, consult a qualied
service technician.
● Mounting screws are not supplied. Use appropri-
ate ones.
● Check all wall mount angle screws for looseness.
● Select a good location. If not, accidents may occur
or the sound bar may get damaged.
● SHARP is not responsible for accidents result-
ing from improper installation.
■ Driving screws
SHARP designed the sound bar so you may hang
it on the wall. Use proper screws (not supplied).
See below for size and type.
3.2 mm
9 mm
22 mm
5 mm
■ Installing the sound bar
1 Fix the pattern paper to the wall in hori-
zontal position as below.
44 mm
509 mm
Wall surface
Pattern paper
(supplied)
548 mm
2 Make a hole on the wall following the screw
point marks on the pattern paper by using
a drill.
Wall surface
32 mm
8-9 mm
3 Fix a wall mount plug into the hole using
a hammer, until it is ush with the wall
surface.
32 mm
8-9 mm
Wall sur
face
4 Fasten the screws to the wall as shown below.
(Total screw is 2 pieces)
Wall surface
Wall surface
Screw using
screwdriver
4.5 mm - 5 mm
Gap from wall
surface
5 Hang the sound bar onto the screws.
Bottom of
sound bar
Spike leg
Double sided
tape separator
System preparation