Filter
Top Products
E-22
Troubleshooting chart (continued)
Remove the iPod, iPhone, iPad, USB memory device and disc
from the unit. Then, set the unit to the power stand-by mode.
Carrying the unit with iPod, iPhone, iPad or USB memory
device left connected or discs left inside might damage the unit.
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on the
disc surface. Follow the guidelines below for maximum
enjoyment from your CD collection and player.
●
Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.
●
Keep your discs away from direct sunlight, heat, and
excessive moisture.
●
Always hold the CDs by the edges. Fingerprints, dirt, or water on
the CDs can cause noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight
out from the centre, along the radius.
Maintenance
Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then with a dry cloth.
Caution:
● Do not use chemicals for cleaning (petrol, paint thinner,
etc.). It may damage the cabinet.
● Do not apply oil to the inside of the unit. It may cause
malfunctions.
Specifications
As part of our policy of continuous improvement, SHARP
reserves the right to make design and specification
changes for product improvement without prior notice. The
performance specification figures indicated are nominal
values of production units. There may be some deviations
from these values in individual units.
■ Before transporting the unit
■ Care of compact discs
■ Cleaning the cabinet
NO YES
Correct
■ General
Power source AC 220 - 240 V ~ 50/60 Hz
Power
consumption
Power on: 26 W
Power stand-by: 0.4 W (*)
Speaker 1-way speaker system
Speaker: 6.5 cm (2-1/2")
Speaker
maximum input
power
50 W/channel
Speaker rated
input power
25 W/channel
Dimensions Width: 475 mm (18 - 11/16")
Height: 191 mm (7 - 1/2")
Depth: 83 mm (3 - 1/4")
Weight 2.7 kg (5.9 lbs.)
( * ) This power consumption value is obtained when the
demonstration mode is cancelled in the power stand-by
mode. Refer to page 4 to cancel the demonstration mode.
■ Amplifier
Output power PMPO: 100 W
MPO: 50 W (25 W + 25 W)
(10% T.H.D.)
RMS: 50 W (25 W + 25 W)
(10% T.H.D.)
RMS: 40 W (20 W + 20 W)
(1% T.H.D.)
Output terminals Headphones: 16 ohms
(recommended: 32 ohms)
Input terminals Audio In (audio signal):
500 mV/47 k ohms
■ CD player
Type Single disc multi-play compact disc
player
Signal readout Non-contact, 3-beam
semiconductor laser pickup
D/A converter Multi bit D/A converter
Frequency
response
20 - 20,000 Hz
Dynamic range 90 dB (1 kHz)
■ USB (MP3 / WMA)
USB host interface ● Complies with USB 1.1 (Full
Speed)/2.0 Mass Storage
Class.
● Support Bulk only and CBI
protocol.
Support file
● MPEG 1 Layer 3
● WMA (Non DRM)
Bitrate support
● MP3 (32 ~ 320 kbps)
● WMA (64 ~ 160 kbps)
Other
● Maximum total number of
MP3/WMA files is 65025.
● Maximum total number of
folders is 999 INCLUSIVE of
root directory.
● The ID3TAG information
supported are TITLE, ARTIST
and ALBUM only.
● Supports ID3TAG version 1
and version 2.
File system
support
● Support USB devices with
Microsoft Windows/DOS/FAT
12/FAT 16/ FAT 32.
● 2 kbyte block length for sector.
■ Tuner
Frequency range FM: 87.5 - 108 MHz
AM: 522 - 1,620 kHz
Preset 40 (FM and AM station)