Filter
Top Products
02/5/27 CD-XP160W(SCA)E3.fm
23
CD-XP160W
Tape Re co rd ing
- Recording to a cassette tape -
Recording to a cassette tape (continued)
Recording from the radio
To stop recording:
Press the
button of TAPE 1.
Note:
If you hear a whistling noise whilst recording an AM station, move
the AM loop aerial.
Erasing recorded tapes
Notes:
Do not connect anything to the MIC socket.
Make sure that the TAPE 2 is not in use.
Dubbing from tape to tape
You can record from TAPE 2 to TAPE 1.
To stop dubbing:
Press the
button of TAPE 1.
1 Tune in to the desired station (see page 18).
2 Load a cassette into the TAPE 1 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3 Press the button of TAPE 1.
4 Press the button of TAPE 1,
which also engages the but-
ton.
5 Press the button of TAPE 1 again to begin recording.
1 Load the tape to be erased into the TAPE 1 cassette compart-
ment with the side to be erased facing toward you.
2 Press the TAPE button.
3
Press the button of TAPE 1, which also engages the
button
to begin erasing.
1 Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette
into the TAPE 2 cassette
compartment. Insert a blank
tape into the TAPE 1 cassette
compartment.
It is recommended that the record-
ing tape is the same length as the
master tape.
3 Press the TAPE button.
4 Press the button of TAPE 1.
5 Press the button of TAPE 1, which also engages the
button.
6 Press the button of TAPE 2.
The button of TAPE 1 will be released automatically and dub-
bing from TAPE 2 to TAPE 1 will begin.