Filter
Top Products
02/5/27 CD-XP160W(SCA)E3.fm
22
CD-XP160W
Tape Re co rd ing
- Recording to a cassette tape -
Recording to a cassette tape
Before recording:
When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
For recording, use only normal tapes. Do not use metal or
CrO tapes.
Recording can be operated in the TAPE 1 compartment. The
TAPE 2 is for playback only.
Recording from a CD (CDs)
You can record 3 CDs continuously.
To stop recording:
Press the
button of TAPE 1.
To perform programmed recording:
Erase-prevention tab of cassette tapes:
When recording on a cassette tape,
make sure that the erase-prevention
tabs are not removed. Cassettes have
removable tabs that prevent accidental
recording or erasing.
To protect the recorded sound, remove
the tab after recording. Cover the tab
hole with adhesive tape to record on the
tape without the tab.
Side A
Tab for
side B
Tab for
side A
1 Press the ON/STAND-BY button to turn the power on.
2 Load a cassette into the TAPE 1 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3 Press the CD button and load the desired disc.
4 Press one of the 1 - 3 buttons on the remote control
to select the disc to be recorded first.
5 Press the button of TAPE
1, which also engages the
button.
CD
playback
and tape recording will start.
1 Press the CD button.
2 Programme discs and tracks (see page 17).
3
Press the button of TAPE 1, which also engages the button.