Filter
Top Products
02/5/27 CD-XP160W(SCA)E1.fm
9
CD-XP160W
Preparation for Use
- System connections -
System connections (continued)
Setting the AC voltage selector
Check the setting of the AC voltage selector located on the rear
panel before plugging the unit into a wall socket. If necessary, adjust
the selector to correspond to the AC power voltage used in your
area.
Turn the selector with a screwdriver until the appropriate volt-
age number appears in the window (110 V, 127 V, 220 V or 230 V
- 240 V AC).
Connecting the AC power lead
After checking all the connections have been made correctly, con-
nect the AC power lead to the AC power input socket, then plug the
AC power lead of this unit into the wall socket. If you plug in the unit
first, the unit will enter the demonstration mode (see page 10).
Notes:
Unplug the AC power lead from the wall socket if the unit will not
be in use for a prolonged period of time.
Never use a power lead other than the one supplied. Otherwise, a
malfunction or an accident may occur.
AC Plug Adaptor
In areas (or countries) where a wall socket as shown in illustration
is used, connect the unit using the AC plug adaptor supplied with
the unit, as illustrated. The AC plug adaptor is not included in areas
where the wall socket and AC power plug can be directly connected
(see illustration ).